Taskalfa 221 c6050

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • bayshoreoe
    Technician
    • Jun 2015
    • 44
    #1

    Taskalfa 221 c6050

    Have this unit throwing c6050 error. Replaced fuser and still does it. Warms up, comes to ready but throws the code when trying to make a copy or in idle. Wall voltage good. Reseated all connections. Any input greatly appreciated.
    Tags: None
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 23008
      #2
      Re: Taskalfa 221 c6050

      How good is the wall power? Did you put your multimeter in the hot - neutral for 10 minutes, or do a power quality analysis? =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • bayshoreoe
          Technician
          • Jun 2015
          • 44
          #3
          Re: Taskalfa 221 c6050

          Reading 121 for over 5 minutes. Fuser powers up on start up, but once machine comes to ready, it never turns back on to keep temperature up, just goes into code.

          Brian

            Comment

            • blackcat4866
              Master Of The Obvious

              Site Contributor
              10,000+ Posts
              • Jul 2007
              • 23008
              #4
              Re: Taskalfa 221 c6050

              121vac hot to neutral? What about ground to neutral? =^..^=
              If you'd like a serious answer to your request:
              1) demonstrate that you've read the manual
              2) demonstrate that you made some attempt to fix it.
              3) if you're going to ask about jams include the jam code.
              4) if you're going to ask about an error code include the error code.
              5) You are the person onsite. Only you can make observations.

              blackcat: Master Of The Obvious =^..^=

                Comment

                • Santander
                  Senior Tech

                  Site Contributor
                  500+ Posts
                  • May 2009
                  • 768
                  #5
                  Re: Taskalfa 221 c6050

                  Originally posted by bayshoreoe
                  Have this unit throwing c6050 error. Replaced fuser and still does it. Warms up, comes to ready but throws the code when trying to make a copy or in idle. Wall voltage good. Reseated all connections. Any input greatly appreciated.
                  After replacing the fuser did you run Sim 163 to reset any fuser error codes, just replacing the fuser does not automatically reset the error codes. You could also run Sim 198 [turn on] Phase control to have the unit eliminate electrical noise caused by the surrounding environment and the unit itself. Blackcat is also correct in making sure that the neutral to ground is wired properly. A simple cheap outlet tester will let you know if the outlet is wired correctly. The routing of the wiring is also important, after replacing the fuser did you run the unit with the cover off? Simply putting the cover on with improper wire routing can cause a wire crimp or a dislodging of a connector. Hoe this helps.

                    Comment

                    Previous template Next
                    Working...