Kyocera KM-2560

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • AlexRust
    Technician

    Site Contributor
    • Apr 2014
    • 41
    #1

    [Error Code] Kyocera KM-2560

    After replacing Hard Drive and performing U906 on Kyocera KM-2560 I am getting message "Unknown toner installed" but we always use OEM.
    Any help to get this machine to recognize genuine toner would be great?
    Tags: code, km-2560, kyocera, oem, toner
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22973
      #2
      Re: Kyocera KM-2560

      I'm thinking that you reset the destination at some point. Check sim U265. For Kyocera it should be 02. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • AlexRust
          Technician

          Site Contributor
          • Apr 2014
          • 41
          #3
          Re: Kyocera KM-2560

          Will definitely try it tomorrow and will post results. Thank you very much.

            Comment

            • AlexRust
              Technician

              Site Contributor
              • Apr 2014
              • 41
              #4
              Re: Kyocera KM-2560

              Yes. U265 was set to "0". Following your instructions did fixed "Unknown Toner..." error. Thanks again. You're the BEST!

                Comment

                • blackcat4866
                  Master Of The Obvious

                  Site Contributor
                  10,000+ Posts
                  • Jul 2007
                  • 22973
                  #5
                  Re: Kyocera KM-2560

                  Congratulations on your success. =^..^=
                  If you'd like a serious answer to your request:
                  1) demonstrate that you've read the manual
                  2) demonstrate that you made some attempt to fix it.
                  3) if you're going to ask about jams include the jam code.
                  4) if you're going to ask about an error code include the error code.
                  5) You are the person onsite. Only you can make observations.

                  blackcat: Master Of The Obvious =^..^=

                    Comment

                    Previous template Next
                    Working...