[Misc] Taskafla 2335

[brantekcc]

good afternoon all

i hope someone can assist me please

i need to find the home position for the lift cam on the DP7100 for Kyocera 2553 please

[brantekcc]

Re: Taskafla 2553

sorry typo its a 2553

[Santander]

Re: Taskafla 2335

Most likely you have a broken pivot point on the backside of the original lift plate. The feeder will cycle through trying to feed an original and error out with misfeed.

[ntbann]

Re: Taskafla 2335

That motor is controlled by sensors.

[brantekcc]

Re: Taskafla 2335

Hi All

i think i have found the issue but not sure how to rectify ,i think the cam that moves the original lift plate is not in home position , i have attached a pic to show
the cam , can any one maybe assist on how to get it back to home position please , the highlighted numbers is the cam i am referring to




DP7100 cam.jpg

thank you in advance

[ntbann]

Re: Taskafla 2335

Like Santander said. Did you check the pin on the back side of the lift plate? That cam is controlled by sensors not by timing.

[sparkycivic]

Re: Taskafla 2335

This cam/motor can be rotated by hand, but all problems I've encountered with this plate are caused by the older design hinge pin that breaks under the excessive spring pressure. Newer plate has steel hinge pin.

[blackcat4866]

Re: Taskafla 2335

This cam/motor can be rotated by hand, but all problems I've encountered with this plate are caused by the older design hinge pin that breaks under the excessive spring pressure. Newer plate has steel hinge pin.

I'll second that. There's a great deal of spring tension on that pin. I was able to repair one by inserting a steel pin and securing it with epoxy. =^..^=

[20gaugeO/U]

Re: Taskafla 2335

Parts Lift Guide Assy SP

p/n: 303R794110

Replaced the plastic pin with a steel one. $5 part and a 15 minute fix.