Kyocera M3040idn feed clutch assy?

[copykat93]

Hi Guys, I have the service & parts manual, but I can decipher what part I need for the primary feed clutch for drawer 1... I have an M3040idn that I can watch the feed roller & shaft kind of stall out, like as if the clutch is slipping while it is trying to feed paper. I thought it would be easy enough to order the clutch for the top drawer, but there really isn't a clear picture of what I need and what part number to order. Has anyone replaced the clutches? I removed the side covers & it looks like it is an entire assy, or can I just replace the clutch for drawer 1? By the way, the machine only has 125K on the meter, I have done the feed rollers & drawer sep assy, but once I saw the feed stall & slip as it's feeding by watching it from the rear, I would presume it needs the feed clutch.

UPDATE:::

I actually removed the clutch pack & cleaned the primary clutch up & am going to reinstall to see if it helped.
Thanks

[CWP]

Re: Kyocera M3040idn feed clutch assy?

Parts manual shows it as:
302MS94051
PARTS DRIVE FEED ASSY SP
40ppm(A4),42ppm(Letter)(A)/40ppm(A4),42ppm(Letter)(AF)/

[copykat93]

Re: Kyocera M3040idn feed clutch assy?

Yes sir... Thats it... I actually found it after I posted... I also tried to clean assy & it made it worse.. I guess I will order the drive feed assy. Thanks CWP

[blackcat4866]

Re: Kyocera M3040idn feed clutch assy?

Did you see any rust dust? =^..^=

[copykat93]

Re: Kyocera M3040idn feed clutch assy?

YES!!!... I sure did... I then went to my copier boneyard and found a pretty low meter (under 200K) M3550idn & I stole the primary feed clutch out of that assy & put it in the M3040 assy & I ran over 200 pages without a jam. I couldn't get more than 20 & it would start to get weak and the clutch would slip. The 3550 clutch did the job & it works really well.

[blackcat4866]

Re: Kyocera M3040idn feed clutch assy?

Congratulations on your success!

I haven't had much luck with cleaning the Daiken branded clutches. =^..^=