Km 3035 Main PCB problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Tebow83
    Technician

    50+ Posts
    • May 2009
    • 92
    #1

    Km 3035 Main PCB problem

    Hi guys,
    having a problem with an km 3035 constantly having an error code of C0630.
    I have tried resetting the error code (u163) it goes away for a second but keeps coming back up on power up.
    I tried putting the latest firmware on but no addition.
    The service manual says dma problem and its a defective main pcb. I firstly swapped the RAM from a machine in the workshop but no joy so i swapped the main pcb and still no joy. Anybody have any problems like this??
    Any help greatly appreciated.
    Cheers
    Tags: 3035, connections, cons, fax, fax kit, main, pcb, power supply, sea
    • Tebow83
      Technician

      50+ Posts
      • May 2009
      • 92
      #2
      oh and i also tried the original ram on the pcb from the machine thats working and firmware update but no luck at all.

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22973
          #3
          I think that I'd start by re-seating the connectors between the CCD PWB and the main PWB.

          On the Falcon IIIs this code is very commonly caused by connection problems at the CIS connector from the document processor to the back of the MFP. Now the Falcon II does not use a dual pass feeder (no CIS), but the other optics can have poor connections also.
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • Tebow83
              Technician

              50+ Posts
              • May 2009
              • 92
              #4
              after spending an age swapping controller, power supply and the scanner board it turned out to be the fax kit causing the problem. We took out the fax kit and its workin no problem so it must of blown. If only the error code had said that

                Comment

                Previous template Next
                Working...