Whats the best product to buy to clean copiers when the toner is ground into the white plastic covers?
-
Sad To Say I Don't Have a Life
I do this stuff on the weekends too -
water
powdered detergent with water
-
Try this:
I've been using it for years. It's safe and effective on most surfaces including your hands. It does a great job on PVC covers (as long as they haven't been chemically etched with something else). You can apply this product full strength up to (5) times to the same area before rinsing with water. After (5) applications there is a risk of etching the surface.
Some techs dilute it 50/50 with water, for use on ink, coffee, and other water based stains.
Since I've started using this product my hands & nostrils no longer crack & bleed. I strongly recomend it. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
cleaning solution update
I use degreaser but on the toner and scuffs I just used a steel brush.... it takes off the plastic and looks worse but if you get a cloth with degreaser on it and rub in the same spot you just brushed you will see a dramatic improvement...
quick note... do not use steel brush on metal part of copier...
and you are actually removing plastic when doing this so do be gentle to the copier...Sad To Say I Don't Have a Life
I do this stuff on the weekends tooComment
-
Simple Green works pretty well. If the covers are really bad you can use rubbing compound followed by Simple Green.But I'm trying, Ringo. I'm trying real hard... to be the Shepherd.
Comment
Comment