I have a KM3530 that has the DF71 finisher, I am needing the sensor located behind the hole punch catch tray. I only have 1 of these in the field so I don't have a parts book. Any help would be appreciated.
-
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
#11Comment
-
In the service manual: Tray Midpoint Sensor
In the parts manual: Main Middle SW Assy.
Fig 3-21
For the entire switch assembly (bracket, flag, spring, PI, etc.): 3AK00210
For the Photointerrupter only: 35327400
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Thank you so much!Comment
-
Sorry, my tech thinks it may be item 16, says it might be labeled something like hole punch waste btl sensor?Comment
-
In the service manual: Scrap Hole-Punch Sensor
In the parts manual: Switch, Partition
Fig 2-24
Part Number: 18327140
This appears to be a microswitch
Is that more like it?
Bottle Sensor.JPG
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment