task alfa 181

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • tulipano
    Trusted Tech
    • May 2010
    • 124
    #1

    task alfa 181

    salve ho un problema su due task alfa181 installate dopo 1000 copie i fogli escono ondulati il foglio esce come onde di mare agitate (quasi a fisamonica).le macchine sono nuove da cosa puo' dipendere?ho cambiato anche la carta ma il problema esce sempre grazie mille

    Hi I have a problem on two task alfa181 installed after 1000 copies of the paper corrugated sheets come out like waves rough sea (almost fisamonica). the machines are new from what may 'depend on? I also changed the card but the problem always comes out thank you very much
    Tags: 100, 1000, 181, carta, copies, installed, paper, pulled, rough, sea, sheets, temparature
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22932
      #2
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • galumina
          Technician
          • Sep 2010
          • 32
          #3
          check to see if exit rollers are grabbing the paper, I have seen it when the paper is not being pulled out because fuser is grabbing paper but the exit does not grab paper thus causing wavy paper. good luck

            Comment

            • JustManuals
              Field Supervisor

              5,000+ Posts
              • Jan 2006
              • 9838
              #4
              This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


              Paul@justmanuals.com

                Comment

                Previous template Next
                Working...