KM 6030 jam codes 65 & 66- constantly

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • habik
    Service Manager

    Site Contributor
    1,000+ Posts
    • Apr 2010
    • 2013
    #16
    Originally posted by blackcat4866
    The fuser gears typically present with J40, J41, J42, J43, J44.
    Jams in the J60's are in the duplex/inverter section. =^..^=

    Yes you are right! I did have however one incident where it would jam in Duplex only. If I have some time tomorrow, I'll try to simulate it.



    Sent from my iDon't believe in marketing device using Tapatalk
    .OK Google! ... will I need Berrocca this morning?
    Firmwares HERE

      Comment

      • Schluken
        Technician
        • Sep 2014
        • 13
        #17
        Re: KM 6030 jam codes 65 & 66- constantly

        This looks like an old thread so I will make this quick. Under the bottom tray of the duplex unit is a switch. Replace that switch and check the next one down the line for cuts in it. I see these a lot in this model and taskalfa 620's. Replacing the upper roller of the duplex unit will only help with j-60 and j-62.

          Comment

          • Tonerkiller
            Senior Tech

            500+ Posts
            • Oct 2012
            • 665
            #18
            Re: KM 6030 jam codes 65 & 66- constantly

            For the j10s clean the oneways in the feed unit and replace the sep arbor

              Comment

              Previous 1 2 template Next
              Working...