copies and prints stained taskalfa 250ci

[marley]

dopo aver aggiornato il fw , le copie e le stampe appaiono con macchie
vedi allegato
dv bk da pulire??

after updating the fw, copies and prints appear with stains see Annex dv bk to clean?

[Metalvoc]

Re: copies and prints stained taskalfa 250ci

you can check and clean for excess toner in and around the black dv unit. Then run U464 AC Calibration, DV and Drum Refresh modes, do your color registration and calibration.

[blackcat4866]

Re: copies and prints stained taskalfa 250ci

you can check and clean for excess toner in and around the black dv unit. Then run U464 AC Calibration, DV and Drum Refresh modes, do your color registration and calibration.

http://www.freetranslation.com/

=^..^=

[marley]

Re: copies and prints stained taskalfa 250ci

provero'
grazie

I'll try '
thanks

[Eric1968]

Re: copies and prints stained taskalfa 250ci

There is a new black development unit which solves this issue. First upgrade firmware to V12 and then replace the black development unit, and run U464. Here in Holland we can claim the old one and get a refund from Kyocera.

[marley]

Re: copies and prints stained taskalfa 250ci

spero di risolvere il problema con la u464
grazie

I hope to solve the problem with the u464 thanks

[Venom]

Re: copies and prints stained taskalfa 250ci

There is a new black development unit which solves this issue. First upgrade firmware to V12 and then replace the black development unit, and run U464. Here in Holland we can claim the old one and get a refund from Kyocera.

We installed new style dev unit on a 400ci and a 552ci and both copiers make really odd noises when running (like a creaky door being opened).

[blackcat4866]

Re: copies and prints stained taskalfa 250ci

We installed new style dev unit on a 400ci and a 552ci and both copiers make really odd noises when running (like a creaky door being opened).

I noticed that too, but it resolved the C7000 and C7101 codes. Imaging what it will be like with all four of them creaking. =^..^=