DF-790 parts enquiry

[tcs04]

Hi,

I'm having trouble finding a part!

Taskalfa5500i... DF-790... Plastic paper guide marked "D6" snapped by customer.

Sits almost vertically, about 4" deep, pivots from the upper edge, sprung.


It's the smaller of and highest up of 2 guide plates.


I've looked at the manual 3 times and seached on line... STILL can't find it!

Any help appreciated.

[blackcat4866]

Re: DF-790 parts enquiry

Is this what you want?:

http://www.copytechnet.com/forums/kyocera-mita-copystar/59123-parts-manual-df790-full-version-please.html

=^..^=

[tcs04]

Re: DF-790 parts enquiry

Is this what you want?:

http://www.copytechnet.com/forums/kyocera-mita-copystar/59123-parts-manual-df790-full-version-please.html

=^..^=

I think so... THANKS!! (Great manuals!!??)

[xeroid]

Re: DF-790 parts enquiry

You can get the parts list but it aint in there last time I looked
303NB24070 Drum Guide is the D6 paper guide
303NB34050 Label D6 is the label

[tcs04]

Re: DF-790 parts enquiry

You can get the parts list but it aint in there last time I looked
303NB24070 Drum Guide is the D6 paper guide
303NB34050 Label D6 is the label

Thanks Xeroid / blackcat / taskalfaman.

Your numbers match, so I'll order the parts... One final question, is there a clip to hold the guide in? I'm not that familiar with this unit and the peg at the front of the guide is missing.

Thanks to all again.

[TripleM160]

Re: DF-790 parts enquiry

You can get the parts list but it aint in there last time I looked
303NB24070 Drum Guide is the D6 paper guide
303NB34050 Label D6 is the label

Where were you able to find those part numbers? I have checked all the manuals and then searched that part number after the fact and still didn't see them.

[Venom]

Re: DF-790 parts enquiry

It is in a bulletin, the front pin breaks so they have redesigned with thicker plastic. I've had 3 broken so far.

[Venom]

Re: DF-790 parts enquiry

One final question, is there a clip to hold the guide in? I'm not that familiar with this unit and the peg at the front of the guide is missing.

All that holds it in is a white plastic C clip.

[habik]

Re: DF-790 parts enquiry

One final question, is there a clip to hold the guide in? I'm not that familiar with this unit and the peg at the front of the guide is missing.

All that holds it in is a white plastic C clip.

Yes, there is a spring at the back that makes the guide to flip to 2 positions - closer to the drum and further apart. A bit ass to get it right.

On the front is white plastic C - clip it should be still attached to the mainframe of the finisher, although it depends where it broke.

I think I was one of the first one to have it broken, man that was a hunt and a half to get the part. Now is available so you should be OK with the numbers above.

Good luck.

[tcs04]

Re: DF-790 parts enquiry

UPDATE

The parts were correct.

The guide is modified with the handle at the front rotated about 30 degrees clockwise and the arrow on the label pionts in a different direction to match. Otherwise fits as before.

Thanks to all who helped.