400ci detached finisher

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • micko_gm
    Technician
    • May 2008
    • 18
    #1

    400ci detached finisher

    Good Day,
    In regards with kyocera mita TASKalfa 400ci,i need to know the procedure of enabling the finisher,or it is enable automatically when connected to machine...
    thank you :-)
    Tags: None
    • kkendric
      Trusted Tech

      250+ Posts
      • Apr 2009
      • 301
      #2
      Re: 400ci detached finisher

      If you connect it and it is not recognized you need to go into the service mode and execute a simulation 906, reset disable function.

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22927
          #3
          Re: 400ci detached finisher

          All Kyocera options are plug & play. If the option is not recognized the most common problems are connectors or the accessory is isolated due to an error. U906 should clear an error. =^..^=
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • micko_gm
              Technician
              • May 2008
              • 18
              #4
              Re: 400ci detached finisher

              thanks guys,i will give you feedback if it's resolve..

                Comment

                • micko_gm
                  Technician
                  • May 2008
                  • 18
                  #5
                  Re: 400ci detached finisher

                  its done,working fine...thanks a lot.

                    Comment

                    Previous template Next
                    Working...