After power on machine shows jam code 00. I have replaced sensor paper path, exit both. Replaced engine pwb. Any solution ?????
-
-
-
Re: Kyocear mita 2050
As you probably already know, J00 means that paper is present at any paper sensor at power ON. Not a specific paper sensor. Any paper sensor.
If I were you, I'd go into service mode and check the state of each sensor to determine which one is actuated. It's a lot easier than just randomly replacing all of them. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: Kyocear mita 2050
Wow. I have sold those machines for over 8 years. Have about 60 in the field. I never knew that cat. I would have had to get out the manual. So I bet a tiny piece of paper is blocking a jam switch. There is a switch lever right below the drum assy. And the spring that pulls that lever back comes off sometimes. Maybe that spring is gone and the lever is not in proper position?Comment
-
Re: Kyocear mita 2050
Sure. It could be any of them. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment