Re: CS 3050ci image problems
Do any of you internal prints print right to the page edge? Look at U089 gray test pattern. =^..^=
Do any of you internal prints print right to the page edge? Look at U089 gray test pattern. =^..^=
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: CS 3050ci image problems
Check the secondary transfer roller assembly,especially the gear,sometimes it detaches from the shaft causing transfer problems on one side only.Comment
-
Re: CS 3050ci image problems
Dear Friend.....
please try to replace this part...... PARTS UNIT HIGH VOLTAGE TRANSFER SP....PART NO: 2K994401.
In my case only Black was problem....solved by replacing....it was escalated call attended by another service Engineer given to me from my Manager.
GOOD LUCK.
Thanks and Regards.
Rashid IqbalComment
-
Re: CS 3050ci image problems
replaced both drum and developer, nothing changed. That part number rashid gave me was invalid. Thinking the cyan laser unit might be dirty in that corner.Comment
-
Re: CS 3050ci image problems
He gave you the alternate part number from the parts manual, Try 302K994401
PARTS UNIT HIGH VOLTAGE TRANSFER SP Item Code: 302K994401 Category: Regular Parts (Parts) Comment
-
Re: CS 3050ci image problems
For those of you who were wondering, we brought in a regional tech, and he determined it was the lasers that went bad and had us order 4 new lasers for the machine. Ill let you know when we get them if it resolves the issue.Comment
-
Re: CS 3050ci image problems
Not to digress, this same regional rep also told us "Half the time when I take apart a 2126, they end up never working again." in reference to our graveyard of them.
Needless to say, Kyocera Color units are a hardly a stroll through the park.Comment
-
Re: CS 3050ci image problems
Just browsing through this thread and really have not give thorough thought to the whole problem. The above in red caught my attention. I have repaired lots of fs-2126 and not one went to the graveyard. yes, they require a bit of work to do the mod, but when done they work fine and usually after assy, works gracefully. replacing four lasers to correct this problem, very, very unlikely, if fact i would say a plain na.
print in monochome only and see if that laser is good, and if good you can swap around the lasers [if they are the same, which i think they are] and start there.
Also, u89 colour belt. what do they look like.THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burkeComment
-
Comment
Comment