Kyocera FS-c2126mfp F000 (C)

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ATSBMCO
    Technical

    50+ Posts
    • Oct 2007
    • 70

    Kyocera FS-c2126mfp F000 (C)

    Hello,
    We have two of the Kyocera FS-c2126+ here that have according to the manual faulty op panel or main PCB.

    Error F000(C)
    The first one works for a bit, about 5-mins, then eventually says F000 on the display. When we reboot the MFP it displays F000 straight away without any motor activation at all. You have to switch it off for 10-mins or so and reboot which then allows it to work for 5-mins again.
    We've re-installed fresh firmware and even tried older firmware too. Plus we've tried the back door firmware reboot system using a CF card too, but it still won't change the way it works. Even tried another op panel.

    The second one just goes straight into displaying F000(C), and won't do anything, and this includes no motor activation at all.

    Has anybody had any success with this fault?

    Help would be appreciated that's for sure.
  • blackcat4866
    Master Of The Obvious

    Site Contributor
    10,000+ Posts
    • Jul 2007
    • 22619

    #2
    Re: Kyocera FS-c2126mfp F000 (C)

    You are correct. It's a communication error between op panel and main PWB. It could be either.

    Most likely the op panel is the less expensive guess. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

    Comment

    Working...