Muratec mfx-1200 "please call service"

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • KyoceraChris
    replied
    Re: Muratec mfx-1200 "please call service"

    fax goddess? Female tech i assume?

    Leave a comment:


  • tjvincent
    replied
    Re: Muratec mfx-1200 "please call service"

    It is fixed, had to replace the entire fuser assy.

    Leave a comment:


  • faxgoddess
    replied
    Re: Muratec mfx-1200 "please call service"

    Did the machine display "PLEASE" call service or just call for service? You can press P, *, 6, right arrow one time to 'service call' and press Enter. If it's a fuser error, you'll see it there. If it says "Service call: 0", then it may be an issue with the scanner assembly.

    Leave a comment:


  • KyoceraChris
    replied
    Re: Muratec mfx-1200 "please call service"

    01 I assume? I will check my manual

    Leave a comment:


  • tjvincent
    replied
    Re: Muratec mfx-1200 "please call service"

    Which was a "1" i believe

    Leave a comment:


  • KyoceraChris
    replied
    Re: Muratec mfx-1200 "please call service"

    it should be giving you a double or single digit code also..

    Leave a comment:


  • tjvincent
    replied
    Re: Muratec mfx-1200 "please call service"

    Looks like I have a fuser melt down, heat and press roller are melted together, thermostat is blown, thermistor is melted to heat roller.

    Leave a comment:


  • JustManuals
    replied
    Re: Muratec mfx-1200 "please call service"

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

    Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads


    Paul@justmanuals.com

    Leave a comment:


  • tjvincent
    started a topic [Dead] Muratec mfx-1200 "please call service"

    Muratec mfx-1200 "please call service"

    Says "please call service" and alarm message is on, scanner moves left to right then back again at power on but lamp never comes on, not sure if it is supposed to or not, checked lamp no continuity, bad lamp ? not sure if those type of lamps are supposed to show continuity or not ?
Working...