If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Can a sr4020 be upgraded to a 4030 by firmware? Ive replaced mpc7500 with a 7501 but the fin was bad, i was trying to use the existing Fin (SR4020)
just wondering if this is possible thanks
Check the point to point wiring diagram and the parts catalog. If the PtoP is the same but b the part number for the PCB is different, yomay have to change the PCB. The problem with the bad Finisher is not the PCB, you have a board.
Comment