[Misc] Ricoh MP C2003 Color registration failed

[richard_hosea25]

Dear friends,

Anybody know how to resolve force line adjuatment failed in ricoh MPC 2003
Already done from d, c and a then b. Even full music is not working,
Honestly, dont know what and how this procedure work, I am greatful if somebody
can explain it. Thanks.

[slimslob]

Re: Ricoh MP C2003 Color registration failed

Dirty or defective image sensor assembly. ITB slippage.

[TonerMunkeh]

Re: Ricoh MP C2003 Color registration failed

On some Metiseseses I've noticed they only like to run C then A. That's brand new, out of the box. If there's no colour registration issue then don't worry about it.

[Codex]

Re: Ricoh MP C2003 Color registration failed

Had same issue with an MPC 2050, clean the Transfer Belt rotation sensor.

[Herostrat]

Re: Ricoh MP C2003 Color registration failed

In most cases cleaning MUSIC sensors is enough,after that do C setting first then A setting twice.
One of the other causes for Line positioning to fail is lighter density on one of the colors because of old developer,or dirty polygon motor mirror.

[copier tech]

Re: Ricoh MP C2003 Color registration failed

Run process control (full music) then check the restults eg 11111111 post the result here

[Vioksrall]

Re: Ricoh MP C2003 Color registration failed

I experienced this issue: install a new transfer belt unit and calibrate again. you can return the old one once it works fine,

[apollo]

Re: Ricoh MP C2003 Color registration failed

Hi

after force line adjustment SP-2111 check results in

SP-2194-7 0 pass 1 faiL

2194-10 , 11 ,12 ,13 FOR EACH COLOURS
RERSULTS SHOULD BE 1 PASS FOR EACH COLOUR

[Polarbear]

Re: Ricoh MP C2003 Color registration failed

Dear friends,

Anybody know how to resolve force line adjuatment failed in ricoh MPC 2003
Already done from d, c and a then b. Even full music is not working,
Honestly, dont know what and how this procedure work, I am greatful if somebody
can explain it. Thanks.

+1 on all the comments above.

Also make sure that your toner levels are good, as low toner supply will cause low density (as said above) which can also cause failure.

Stupid question: How old is the machine?

You did check the ITB belt for wear or tears in the belt itself?
Clearly visible wear areas in line with the sensors will also cause line adjustment to fail.

Also check the belt surface for dings or dents in the belt surface as imperfections in the sensor areas (close the front, middle and rear of the belt) can cause LP failures.