[Error Code] SC670 Mpc2550

[finhocamargo]

good night, I have a machine that takes a lot to call, when it appears with code sc670 and I can not enter the technical mode to cancel, can someone help me?
I thought about updating it, would that solve it? or is the BICU board bad?

[jonhiker]

Re: SC670 Mpc2550

An SC670 code is a controller error. You can try unplugging the hdd and see if it will boot with limited functions. You may need to replace the controller board and the ipu as a set.

[copier tech]

Re: SC670 Mpc2550

Yes sounds like a controller issue, I would first try updating the fw, if it will not boot off your fw sd card then I would replace the controller.

However you could also try "reseating" all the controller connections, inc ram etc nothing to loose.

[finhocamargo]

Re: SC670 Mpc2550

the problem is that it is not letting me enter the simulation to clear the settings

[finhocamargo]

Re: SC670 Mpc2550

I downloaded the firmware update, I'll try to do it today

[slimslob]

Re: SC670 Mpc2550

the problem is that it is not letting me enter the simulation to clear the settings

That is because is a controller boot error, not a fusing error. The error code cannot be cleared through SP mode. You must correct the cause of the error. Once you have done so, the error will be gone.

[finhocamargo]

thank you

[finhocamargo]

Re: SC670 Mpc2550

Good afternoon, I've tested the boards on another machine and they're all working.
DRB, BCU, CONTROLLER and HDD.
help!!!

[bob marley]

Re: SC670 Mpc2550

I've tested the boards on another machine and they're all working.
DRB, BCU, CONTROLLER and HDD.!

check the connection between the BCU and controller