MP 5000 toner motor replacement....

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Copyman2000
    Junior Member
    • Apr 2015
    • 6
    #1

    MP 5000 toner motor replacement....

    OK this easy job went bad. Normally the wire pops out of the front of the motor and I just pop it in the new motor...

    Wire pulled out of the rear frame and frame connector fell into the machine...

    Any clues on how to get that fan housing out of the middle of the machine to get to the rear frame from the front of the machine...

    Thanks,
    Harry
    Tags: frame, front, motor, rear
    • TonerMunkeh
      Professional Moron

      2,500+ Posts
      • Apr 2008
      • 3865
      #2
      Re: MP 5000 toner motor replacement....

      If you're trying to get to the bit I think you are, take the laser, power supply and the output cover off, that should give you sufficient access to the fan duct.
      It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.

      Hit it.

        Comment

        • Copyman2000
          Junior Member
          • Apr 2015
          • 6
          #3
          Re: MP 5000 toner motor replacement....

          Originally posted by TonerMunkeh
          If you're trying to get to the bit I think you are, take the laser, power supply and the output cover off, that should give you sufficient access to the fan duct.
          Thank you for helping!

          Actually I fixed it this morning....

          Removed the bridge unit, 2 blue covers and 2 screws on the fan housing!!!!

          What a PITA!!!

            Comment

            Previous template Next
            Working...