SR 3130

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • aktasson
    replied
    Re: SR 3130

    Originally posted by cujo41
    It was resolved by replacing gathering roller. Did not have many miles on roller but felt like it was wet.
    Thanks for the feedback (y).

    Leave a comment:


  • cujo41
    replied
    Re: SR 3130

    It was resolved by replacing gathering roller. Did not have many miles on roller but felt like it was wet.

    Leave a comment:


  • Phil B.
    replied
    Re: SR 3130

    yup old eyes

    Leave a comment:


  • cujo41
    replied
    Re: SR 3130

    I will check the belts and rollers. It is odd that it does not happen all of the time.

    Leave a comment:


  • aktasson
    replied
    Re: SR 3130

    Originally posted by cujo41
    I have an MPC3003 with an internal finisher that when stapling the first and last pages are fine, but page 2 and sometimes page 3 exit finisher but do not get pulled back in to staple. I have updated firmware. This does not happen all the time but mostly when stapler 4 or fewer pages.
    I repair the internal fin very often in the field with problems like this. First have a look to the reverse and gatherin roller. My personal suggest I would swap the rollers first and clean the internal frame from the staple craps with a magnetic tool. I would lubricate the axle of the staple head with machine oil too.
    36790.jpg
    1xD5862332 GATHERING ROLLER
    1xD5862052 REVERSE ROLLER:FRONT:ASS'Y
    1xD5862051 REVERSE ROLLER:INNER B ACK:ASS'Y

    Leave a comment:


  • copier tech
    replied
    Re: SR 3130

    Originally posted by Phil B.
    you never mentioned the model of the finisher... does it kick any error codes?

    Leave a comment:


  • Phil B.
    replied
    Re: SR 3130

    Originally posted by cujo41
    I have an MPC3003 with an internal finisher that when stapling the first and last pages are fine, but page 2 and sometimes page 3 exit finisher but do not get pulled back in to staple. I have updated firmware. This does not happen all the time but mostly when stapler 4 or fewer pages.
    you never mentioned the model of the finisher... does it kick any error codes?

    Leave a comment:


  • Phil B.
    replied
    Re: SR 3130

    check the operation of the jogger arms/belts in the finisher. Sounds like they need to cleaned or replaced .

    how many prints are on the unit?


    what have you tried?

    Leave a comment:


  • cujo41
    started a topic [Misc] SR 3130

    SR 3130

    I have an MPC3003 with an internal finisher that when stapling the first and last pages are fine, but page 2 and sometimes page 3 exit finisher but do not get pulled back in to staple. I have updated firmware. This does not happen all the time but mostly when stapler 4 or fewer pages.
Working...