Ricoh MPC 300 firmware

[ChrisG]

Is anyone available out there that would have a recent firmware update for this model? Have a customer who's machine has started glitching with SC670 codes and want to try this before venturing down the road of replacing boards.

Thanks
Chris
TJL Copy

[tufbnme]

Re: Ricoh MPC 300 firmware

I have it.

[tufbnme]

[copier tech]

Re: Ricoh MPC 300 firmware

Is anyone available out there that would have a recent firmware update for this model? Have a customer who's machine has started glitching with SC670 codes and want to try this before venturing down the road of replacing boards.

Thanks
Chris
TJL Copy

I have the exact same issue except its on an MP C401.

Mine won't come to ready or accept a fw update.

If yours is an intermittent issue manual states update firmware then replace the controller.

[slimslob]

Re: Ricoh MPC 300 firmware

Have you tried accessing WIM? If you can try updating System and then Engine using .rfu firmware.

[copier tech]

Re: Ricoh MPC 300 firmware

Have you tried accessing WIM? If you can try updating System and then Engine using .rfu firmware.

Good shout will try but I had no LAN leds on NIC seemed dead.

[fshead]

Re: Ricoh MPC 300 firmware

like others have chimed in I now pull all toner bottles out b4 knowing it is a true sc670.
I dont know what the RFID brds have to do with it but have seen toner chip,dirty contacts or other
give false alarms..

[fshead]

Re: Ricoh MPC 300 firmware

it s odd i just had a shop machine mpc300 that took a while to show ready that coded sc670/
I restarted it a few times and no change.
I then took all toners out and turned back on wth front door open.
Machine did not code again wth door open or close.
I swapped different used toners one at a time and now it seems ok.