Replace Toner will not clear Lanier LD425c

[zed255]

Re: Replace Toner will not clear Lanier LD425c

The newer style (D029) will work in the older machines. They new ones have a smaller clutch than the old ones, but mount points, harness and hose are the same. If you can't get the original style then get one for a Ricoh MP Cxx01 or MP Cxx02 series and you should be set. And don't be lazy, the new pump includes the hose for a reason, install it.

Don't waste your time and effort trying to resurrect the old one. Some say they have but guaranteed it will fail again. Just replace it.

[fshead]

Re: Replace Toner will not clear Lanier LD425c

The newer style (D029) will work in the older machines. They new ones have a smaller clutch than the old ones, but mount points, harness and hose are the same. If you can't get the original style then get one for a Ricoh MP Cxx01 or MP Cxx02 series and you should be set. And don't be lazy, the new pump includes the hose for a reason, install it.

Don't waste your time and effort trying to resurrect the old one. Some say they have but guaranteed it will fail again. Just replace it.

I dont think you can use a mpc330 pump on the mpc2500..
I tried using a mpc2500 pump on my mpc3300 and they did not fit...
I know mpc3300/mpc2800,mpc3501,mpc3502 all cross over..and the print models too spc830 etc..

[fshead]

Re: Replace Toner will not clear Lanier LD425c

you can also put a pump of another color better if new, before I revised the old ones and changed the rubber inside but it was time wasted and then lasted less, not convenient

i just swap a color in just to get them up "temp" for b/w,maybe do a forced cyan feed b4 pulling a cyan pump....