I cant seem to find the solution to this error. I removed the transfer chrg assy. to eliminate it . I also unplugged the high voltage transformer board to eliminate it and still getting this error . The machine warms up but as soon as it trys to cycle it displays this error code. I know that it has something to do with charging but if I eliminate the chargers shouldnt it still cycle?Any Ideas anyone.
-
-
Check the toner door switch as well. I've run into the same problem before, and it was caused by a faulty switch.
The only other things I can come up with off the top of my head are the CGB power pack or the corona assembly, but you've already checked those. I'd go with the switch to start.
Good luck!Today's subliminal quote is: -
I think that the 300-xxx error is for charge, and 400-xxx is for transfer.
The charge assemblies can get flaky in these wide format machines.Bachelor of Science in Information Technology, Comptia A+, Comptia Network+Comment
-
Replace the charge and grid wires. I've had several of these throw the code before the PM cycle. Usually they are in small rooms. Also clean the housing of ozone. I've also had 2 that needed the entire housing.the savin2535 is displaying well bet the hiter lamp is not shining and the lamp had been tested o.k.please kindly help.Samir: No, not again. I... why does it say paper jam when there is no paper jam? I swear to God, one of these days, I just kick this piece of shit out the window.
Michael Bolton: You and me both, man. That thing is lucky I'm not armed.Comment
Comment