If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
You would not believe this...
I was planning to update the firmware per every 2 items.
I have 2 SD cards and had already put 2 items on each card at the office before i went to customer.
At customer, I put one SD card in, put power on... 'waiting for firmware...' and than the whole romdata list was displayed!!!!!!
I wonder what was wrong, but did the update...
I had then 8 items succesfully updated.
I Printed out the diagnostic page afterwards and confirmed the update.
I checked the SD card and there were only 2 items on that card!!!!!!!!
I do not believe in ghosts, there must be a simple explanaition for this.
Anyone?
If the machine was displaying a list of romdata files then they must be on your card.
They could be hidden files so Windows won’t see them but the copier can.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
Comment