mp c4503 jAM IN c BUT NO PAPER IN C

[digicor]

Ive cleaned all the sensors in the fuser, and the exchange exit gate just outside the fuser .... there was nothing , i was running some test pages all good then a jam and now it wont clear
im thinking the exit gate sensor or fuser entrance sensor went bad?
any hints thank you

[davel]

What is the jam code

[Ricoh-ono]

If you are getting jam code 17, then it is the fusing sleeve. You can run the input checks to test sensors.

[digicor]

Jam code J001
all sensors in this area are working as inm 5803 , i have to think its not re setting?
th right side door sensor is wroking as well

[digicor]

If you are getting jam code 17, then it is the fusing sleeve. You can run the input checks to test sensors.

i replaced the fuser and the exit assembley

[slimslob]

Jam code J001
all sensors in this area are working as inm 5803 , i have to think its not re setting?
th right side door sensor is wroking as well

J001 is a jam found when the power is turned or the last door is closed, Check the jam history. J001 is not recorded in the history as it is not a true jam. The last recorded jam will tell you where the last jam was and that would be where there might be a bad sensor or a scrap of paper. Also check Input Checks to see if there is a door that is shown as open even though it appears closed.

[digicor]

thanks ill check into it tomorrow.

[digicor]

Okay, i ended up using a half a can of Spray air, blew out all the sensors,even though they were all working according to 5-803 but i think what cleared it is the kinda tunnel the first registration sensor looks through in B at the bottom where the paper first enters the B section, Not really sure,i sprayed into that with air as well, and there was toner all over the back inside of the paper drawers one and two, i had a big toner mess in the back on the right side from a PCDU leak, but it was cleaned up and the machine was running when this C jam occurred.so its cleared .
thank you for all the help.

[digicor]

J001 is a jam found when the power is turned or the last door is closed, Check the jam history. J001 is not recorded in the history as it is not a true jam. The last recorded jam will tell you where the last jam was and that would be where there might be a bad sensor or a scrap of paper. Also check Input Checks to see if there is a door that is shown as open even though it appears closed.

Okay, i ended up using a half a can of Spray air, blew out all the sensors,even though they were all working according to 5-803 but i think what cleared it is the kinda tunnel the first registration sensor looks through in B at the bottom where the paper first enters the B section, Not really sure,i sprayed into that with air as well, and there was toner all over the back inside of the paper drawers one and two, i had a big toner mess in the back on the right side from a PCDU leak, but it was cleaned up and the machine was running when this C jam occurred.so its cleared .
thank you for all the help.