mpc3002 jams with tray 1 paper did not move

[Mark Bbb]

I replaced tray 1 paper feed unit ass'y with a referbished one (new one way's and paper feed rollers).
Problem remains.
I checked the serv manual 3002 & 3001 for details about the paper feed mechanisme, but there is no chapiter "detailed descriptions" there. mpc3000 has this chapiter, but is it the same mechanism?
Anyone can throw me a bone here? .
Thanks

[Mark Bbb]

Re: mpc3002 jams with tray 1 paper did not move

Do you use the pick up belt D0892830 for mpc3001 or just the AF030085 (as i do)?

Paper feed rollers:
AF030090 serie MP4000 GREEN
AF030085 serie C2800 C3001 C3002 ORANGE
AF030094 serie C3003 C3004 GREEN

Paper feed units:Referbish paper feed units
Replace levers G0652767 & AB011218

[Mr Magic]

Re: mpc3002 jams with tray 1 paper did not move

I replaced tray 1 paper feed unit ass'y with a referbished one (new one way's and paper feed rollers).
Problem remains.
I checked the serv manual 3002 & 3001 for details about the paper feed mechanisme, but there is no chapiter "detailed descriptions" there. mpc3000 has this chapiter, but is it the same mechanism?
Anyone can throw me a bone here? .
Thanks

If the rollers are not making contact with the paper to pull it through, check the solenoid, the door cable/connector or the main board. More likely it's the connector not pushed all the way in.

[Gift]

Re: mpc3002 jams with tray 1 paper did not move

These pick up belts were the biggest crap - we also use regular pick up rollers. You might need an additional plastic washer in order to keep that whitish/yellowish rholder thingy properly in place, otherwise it might got stucked and the pick up roller won't move downwards.

[luca72]

Re: mpc3002 jams with tray 1 paper did not move

I replaced tray 1 paper feed unit ass'y with a referbished one (new one way's and paper feed rollers).
Problem remains.
I checked the serv manual 3002 & 3001 for details about the paper feed mechanisme, but there is no chapiter "detailed descriptions" there. mpc3000 has this chapiter, but is it the same mechanism?
Anyone can throw me a bone here? .
Thanks

hi, try replacing the tray.
it happened to me that the rear part, honestly made of plastic a bit too light, tends to deform and move forward when the drawer is inserted, and the station operating lever does not work correctly, alternatively (as I do io) you can apply / glue a piece of thick, cut-out plastic to that point on the tray