mp 2000

[slimslob]

Re: mp 2000

yes, but ihave replaced hotroller with a genuin one. also it looks to me that hot roller is too hot.

Too hot or too cold for the paper thickness can cause offsetting.

[Phil B.]

Re: mp 2000

Too hot or too cold for the paper thickness can cause offsetting.

+1

Sent from my SM-G960U using Tapatalk

[KeviM]

Re: mp 2000

yes, but ihave replaced hotroller with a genuin one. also it looks to me that hot roller is too hot.

Check your hot roller and fuser unit again. Check your temperatures like the other engineers said.. . Then

If you have another PCDU imaging unit, preferably a good second hand unit, put it in and run about 200 prints. If it stops the repeat image after about 100 prints then you have your answer. Use a different toner as well

[Gift]

Re: mp 2000

And what about the press roller bushings as GIUBOSS suggested? Press roller itself can also loose it's diameter and stiffness over time, especially the "foamy" ones.

[KeviM]

Re: mp 2000

And what about the press roller bushings as GIUBOSS suggested? Press roller itself can also loose it's diameter and stiffness over time, especially the "foamy" ones.

Agreed 👍🏼