[Misc] Imc 3000-controler-nvram zero counter

[Johnysg11988]

Hello
I' ve imc3000.I had proplem with controler board and nvram zero counter due electricity issue.I replaced the parts but the copier shutdown after one minute when start up

Ant suggestions..

[slimslob]

Re: Imc 3000-controler-nvram zero counter

You may have additional issues.

[Johnysg11988]

Re: Imc 3000-controler-nvram zero counter

You may have additional issues.

Nop..because replaced the parts on onother new machine and the problem to be tha same

[copier tech]

Re: Imc 3000-controler-nvram zero counter

Nop..because replaced the parts on onother new machine and the problem to be tha same

If you have another machine to 'borrow' boards from try the the BICU and power supply.

[Oze]

Re: Imc 3000-controler-nvram zero counter

Any codes displayed at all?

[Johnysg11988]

Re: Imc 3000-controler-nvram zero counter

Any codes displayed at all?

No nothing..copier shutdown after "please wait"

[Oze]

Re: Imc 3000-controler-nvram zero counter

No nothing..copier shutdown after "please wait"

I KNOW this sounds like a stoopid question but check that the nvram is facing the right way.
Make sure that the "D" impression in the eprom matches the impression on the board...it fits BOTH ways but only works ONE way.

[Gift]

Re: Imc 3000-controler-nvram zero counter

I think he wrote that the parts don't work on another, new IMC with the same symptome.

What happens with the original NV Ram? Same problem?

Did you order the corrent part number? Ricoh Manuals can be a bit confusing sometimes - in the past you got a SC though, I managed that myself thanks to using an outdated parts manual LOL
And yes, the NV Ram fits in both ways but you should look for the markings to choose the proper way - guess we all learned that at some point, too

Not shure if that's valid anymore but did you compare/adjust the Dip SW?

Does this board use onboard RAM or a module? In case there's a module you should cross-check that, too.

[TonerMunkeh]

Re: Imc 3000-controler-nvram zero counter

That sounds like the ops panel main board.

[Johnysg11988]

Re: Imc 3000-controler-nvram zero counter

I KNOW this sounds like a stoopid question but check that the nvram is facing the right way.
Make sure that the "D" impression in the eprom matches the impression on the board...it fits BOTH ways but only works ONE way.

Thanks a lot...finaly ram was the problem