Photoconductor unit not set correctly ricoh mpc3003

[Pixtech Frameworks]

Hi All,
I am currently battling a Ricoh mpc3003 whose welcome not is Photoconductor Unit not Set for Cyan, Black and Yellow. I tried putting another unit from 6003 same thing. What could be the cause. Your contributions are highly appreciated.

[semi]

Re: Photoconductor unit not set correctly ricoh mpc3003

Bent pin on one of the connectors-look very closely

[GIUBOSS]

Re: Photoconductor unit not set correctly ricoh mpc3003

Hi All,
I am currently battling a Ricoh mpc3003 whose welcome not is Photoconductor Unit not Set for Cyan, Black and Yellow. I tried putting another unit from 6003 same thing. What could be the cause. Your contributions are highly appreciated.

I would like to know if the groups are original, the toners? Try to pull them, clean the chip contacts. Check that all doors are closed correctly

[Pixtech Frameworks]

Re: Photoconductor unit not set correctly ricoh mpc3003

I've found solution, I had to unplug the the developer unit cable of all the Units and remove them, open side paper transfer section and front cover for 3hrs. Inserted units back and power on machine and it was back to normal

[GIUBOSS]

Re: Photoconductor unit not set correctly ricoh mpc3003

I've found solution, I had to unplug the the developer unit cable of all the Units and remove them, open side paper transfer section and front cover for 3hrs. Inserted units back and power on machine and it was back to normal

You've also solved in economics ... Ricoh also plays these fake contact jokes

[Pixtech Frameworks]

Re: Photoconductor unit not set correctly ricoh mpc3003

You've also solved in economics ... Ricoh also plays these fake contact jokes

Exactly, could be contact malfunctions.

[slimslob]

Re: Photoconductor unit not set correctly ricoh mpc3003

Exactly, could be contact malfunctions.

More that likely the 3 hour wait was not needed.

[Pixtech Frameworks]

Re: Photoconductor unit not set correctly ricoh mpc3003

More that likely the 3 hour wait was not needed.

I decided to wait 3hrs cos I've tried different Photoconductor units, still the unit not set correctly.. So I unplugged all cables and all doors

[Zaxxon]

Re: Photoconductor unit not set correctly ricoh mpc3003

More that likely the 3 hour wait was not needed.

agree! 2.30 hours should be enough

I decided to wait 3hrs cos I've tried different Photoconductor units, still the unit not set correctly.. So I unplugged all cables and all doors

unplugging all

[Pixtech Frameworks]

Re: Photoconductor unit not set correctly ricoh mpc3003

agree! 2.30 hours should be enough



unplugging all

Really?? Then what was needed to do??? Does it mean a machine error was detected??.

[slimslob]

Re: Photoconductor unit not set correctly ricoh mpc3003

Try the following:

1. Use the control panel power to turn the C3003 off
2. Unplug the power cord
3. Press and hold the control panel power button until the power LED flashes, normally about 10 seconds.