Mp c3004 ex

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • luis_p712
    Junior Member
    • Jun 2014
    • 9
    #1

    Mp c3004 ex

    Hello, any scope with this problem of accumulation of development in the middle. check that there are no obstructions but there is nothing. Thank you very much in advance.
    Attached Files
    Tags: advance, c3004, middle, obstructions, scope
    • GIUBOSS
      Service Manager

      Site Contributor
      1,000+ Posts
      • Jul 2013
      • 1382
      #2
      Re: Mp c3004 ex

      Have you tried manually rotating the magnetic roller? Is this a new or refurbished unit?

        Comment

        • luis_p712
          Junior Member
          • Jun 2014
          • 9
          #3
          Re: Mp c3004 ex

          Yes, turning manually does not present a problem. only when working

            Comment

            • GIUBOSS
              Service Manager

              Site Contributor
              1,000+ Posts
              • Jul 2013
              • 1382
              #4
              Re: Mp c3004 ex

              Is this a new or refurbished unit? The problem is in the unit

                Comment

                • davel
                  Technician

                  1,000+ Posts
                  • Oct 2011
                  • 1077
                  #5
                  Re: Mp c3004 ex

                  If PM count for this unit is over recommended just replace unit.

                    Comment

                    • tjvincent
                      Trusted Tech

                      250+ Posts
                      • Apr 2008
                      • 280
                      #6
                      Re: Mp c3004 ex

                      See bulletin 034, order a new development cover sheet, PN# M0AJ3138

                        Comment

                        • 8T2
                          Trusted Tech

                          250+ Posts
                          • Aug 2015
                          • 257
                          #7
                          Re: Mp c3004 ex

                          i just grab the top plastic cover in the centre where the developer is gathering and pull it up and away from mag roller for a few seconds.

                          these pcdu's are heavy and that cover deforms easily while handling it if you're not careful

                          Sent from my SM-A305F using Tapatalk

                            Comment

                            Previous template Next
                            Working...