Aficio 1045 sc326

[Guest]

Rcv fax ok, rcv prints ok, select copy & press start paper gets to registration rollers and sc 326 is generated. Changed the LD unit and got same results. Any hepl would be appreciated.

[YHEL23]

Rcv fax ok, rcv prints ok, select copy & press start paper gets to registration rollers and sc 326 is generated. Changed the LD unit and got same results. Any hepl would be appreciated.

Try this tb..Hope can help..Good luck

[stephend]

Rcv fax ok, rcv prints ok, select copy & press start paper gets to registration rollers and sc 326 is generated. Changed the LD unit and got same results. Any hepl would be appreciated.

So you can print 1000 sheets and no sc 326?
It happen only in copy mode?
And everything else mechanically is in a good shape I suppose...clutches, feed tires, mylars, etc...
Did you replaced the LD unit with a new one?...or just poly motor.

Check the connection between LD sync board and the LD unit itself. Also check the connection between LD unit and BICU. Change the BICU from other machine....first back up NVRam before you start.

[Bob]

I put a known good laser unit in the machine , did laser beam pitch adjustment. Same end result, fax ok, print ok, and copy no go.

[stephend]

I put a known good laser unit in the machine , did laser beam pitch adjustment. Same end result, fax ok, print ok, and copy no go.

If you can send out faxes...your HDD and optical system is good. If you can print your laser unit it's working fine.
Try to replace the BICU. Back up NVRam & address book first, replace the BICU, do a 5801 and start from the scratch.

[Fearless V K]

Door switches? These can cause strange problems.

[imaginemoko]

agree... try to check micro switches... and clean the sync detector... bring spare...

[MaiHoang]

Aficio AF 1035 copy not go. Replaced poly motor - now SC 322 code. Pls help me . Thanks a lot .

[Paper_Jam]

I think someone else said it too in this thread, replace the door switches!

[tcs04]

I think someone else said it too in this thread, replace the door switches!

The ones above the fuser! Has the machine been leaking toner? If so. this will blow over the switches.

[MaiHoang]

So you can print 1000 sheets and no sc 326?
It happen only in copy mode?
And everything else mechanically is in a good shape I suppose...clutches, feed tires, mylars, etc...
Did you replaced the LD unit with a new one?...or just poly motor.

Check the connection between LD sync board and the LD unit itself. Also check the connection between LD unit and BICU. Change the BICU from other machine....first back up NVRam before you start.

I did and it ok - Thanks of all.

[max toby]

Well....

What happened? was it the door switches? was it the ribbon cable? what happened, I need to know too. Also, can anyone tell me what happened to Scanrouter V2 Lite? and if V2 Lite is gone,which version are you supposed to use now? I guess i sound like i fell off the turnip truck, but I am really just short of screwed here. Sounds like an LD unit to me, but they are like 500 bucks or something. Not even worth it in my books. But hey, I just fix em.

Peace
Max

[max toby]

well...

I tried the door switch idea, with no sucess. And I changed em all. One one of the machines I tried the LD Pitch adjustment 2-103-1,2,3,4 all set back to default, and no 326 so far. Here's hoping.

Thanks, and I'll keep you posted.

Peace
Max