I have a 2105 that is getting a band through the half tone areas from front to rear. The machine has 700K the 600k pm was done drum, developer, transfer, fuser. They are running 8.5 x 11 images 2 up on 11x17 and I get one line about 4 inches from the lead edge. The line is about a half inch wide and it just looks darker than the surrounding area.
I didn't try 8.5 x 11 because I went out and put a new corona in it and they were happy. I left then they said it came back a couple hours later.
Sorry I don't have a scan.
I think I remember something about this but the tsc site is dead now so I can't check.
I didn't try 8.5 x 11 because I went out and put a new corona in it and they were happy. I left then they said it came back a couple hours later.
Sorry I don't have a scan.
I think I remember something about this but the tsc site is dead now so I can't check.
Comment