Can't get rid of this 555 code. Repl-stors/checked lamps and stats ok. Lamps are not firing up. Checked fuses on lvps all ok. Leaning toward the lvps. Ideas appreciated. Thanks t
-
-
Not on that machine, it was on a Konica 7075, but I had once that problem because the rear connector on the machine side wasn't making proper contact, hence the lamps didn't get power (I also got a nasty shock when checking if the connector had any power - please, don't ask!
)
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation! -
Isn't 555 for the Web? Set SP2902-001 to 0Comment
-
550's web. Try the fuser exit sensor harness - I've seen one chafing against the frame shorting out, causing SC555.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
-
555 web end detech.
Check web has not worn out. Watch out as the sns arm some times it sticks. If you have not got a web you can reverse it. Then go into sp mode SP1902-2 =SP1902-4 . 1=lenght of web 2=% of time left on web for machine to tell use to call you.
Have fun , Good luck
Comment
-
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
-
Yeah TonerMunkeh is right 550 is the web end. People always seem to think it's 555 for some reason.
Is it trying to come to ready after you reset it or does the code come up as soon as you power on ?Comment
-
real small crack on one of the lamp ends. thanks guysComment
Comment