Aficio 2238c Fuser gears parts numbers

[zoran.riko]

HI,
I Have problem How to find parts numbers for 3 small gears on the upper part of the fuser unit. In My Parts index they are missing. If anyone have this parts numbers, PLS

[Eric1968]

Are these the right ones?

G080 4192 Gear:Oil Supply Roller:No.2
G080 4195 Gear:Oil Supply Roller:No.2:Front 1

G080 4194 Gear:Oil Supply Roller:No.1 1

[Froota]

HI,
I Have problem How to find parts numbers for 3 small gears on the upper part of the fuser unit. In My Parts index they are missing. If anyone have this parts numbers, PLS

AB01 2022 Gear:Pressure-Drive
AB01 2023 Gear:Fusing
AB01 2024 Gear:Idler:Pressure:Exit:Z19
AB01 2021 Gear:Idler-Drive

Together with the 3 gears from eric1968 are those the only gears in a fusing.
For the 2228-2232-2238 series, we replaced the whole fusing unit. And for the 3245c in spare parts.

regards,
Froota

[Eric1968]

He must have the right gears now! :-)

[zoran.riko]

The first one is ok, but the two others are on the same side of the first gear. The second and third gear part numbers You wroted are on the same shaft with the two gears I needed, but from the oposite side of the fuser

[zoran.riko]

There are three small gears on the top left side next to the upper heating lamp in the fuser belt

[Froota]

The first one is ok, but the two others are on the same side of the first gear. The second and third gear part numbers You wroted are on the same shaft with the two gears I needed, but from the oposite side of the fuser

So, isn't it the following gear then?

AB01 2023 Gear:Fusing

This one is on the side of the G080 4192....

gr

[zoran.riko]

No, they should be placed next to
G080 4192 and upper heating lamp

[Herrmann]

There are some gears attached to the frame of the Fusing Unit, you can not change them. Just replace the whole Assy, its very reasonable.

And Froota, for the 3245c you can take the Fusing Unit for the CL7300, just interchange the connector with the red wires at the underside ; saves time and money.

[Froota]

There are some gears attached to the frame of the Fusing Unit, you can not change them. Just replace the whole Assy, its very reasonable.

And Froota, for the 3245c you can take the Fusing Unit for the CL7300, just interchange the connector with the red wires at the underside ; saves time and money.

Thx for the tip!

[kkwong0209]

Hi Zoran.riko, have u got the parts no? I also looking for that parts.

[zoran.riko]

HI,
I did not find the part numbers but I find that BRAND NEW FUSER UNIT genuine from Ricoh is under 100 EUR and Iam replacing whole unit and from replaced ones use gears where a necessary. All customers and We of coarse are very satisfied. Regards !