This puppy is marking the back of the copy paper with a grey line about 1/2" wide that spans the entire length of the lead edge (front to rear). The front of the copies looks good. If you've come across this please advice. Thanks.
-
-
PM time!!!! -
Its overtoned. You can try detoning but I would just replace the developer and reset the AT. The transfer roller is probably ready for replacement too. As this is where the dirt is coming from.sigpic
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+Comment
-
2020d back page ground
Hi Check your smc to see how many copies are on the developer if over 60k time to change
you could also turn on the transfer roller cleaning ( 2 996 1) and also the transfer current adj
(2 301 4 ) hope this helpsComment
-
just clean the transfer roller by using wet & dry cloths , the gray line will goneComment
-
the transfer roller needs to be cleaned, tooComment
Comment