Ricoh 1022 jams at reg roller and just says "copying"

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • DCW98
    Technician
    • Jun 2010
    • 11

    #16
    SBCU is 1 of 5 boards in the back, so you got that one ruled out.
    Therefore only SBU could be the problem of SC193 in my opinion, it's the only step left in image processing.....
    SBU is also a common reason for giving SC101 so the link between the codes might be in this board.
    For info: The SBU is combined in the lensblock

    You got a tough one here i got to say, but i admire you perseverance :-)

    Please give update on your result...

    Comment

    • Fearless V K
      Senior Tech

      500+ Posts
      • May 2007
      • 620

      #17
      Goose Guide says...

      B022/B027
      SC 101
      - mirrors out of position
      - replace lens holder assembly with SBU board attached
      - replace power supply
      Don't take that toner with me!

      Comment

      • copyaction
        Senior Tech

        Site Contributor
        500+ Posts
        • Oct 2007
        • 985

        #18
        It was the cable from the lensblock to the back of the machine.
        thanks again to everyone!

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22973

          #19
          Congratulations on a difficult fix. This is one of those that can drag out way too long. =^..^=
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

          Comment

          Working...