Frozen Lanier 266cn Printer

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • onegreatsteak
    Technician
    • Jan 2010
    • 14
    #1

    [Dead] Frozen Lanier 266cn Printer

    I have a Lanier LD226cn printer. When turned on it will go to please wait then no further. Will not go to SP mode, will not show error if I take fuser out. Tried to update firmware just to see if something happened, nothing. Anyone seen this before? I suspect the controller board but I would like other opinions before spending money.
    Last edited by onegreatsteak; 06-29-2010, 08:15 PM.
    Tags: bad, before, connector, controller, error, firmware, froze, frozen, fuser, lanier, mode, money, nec, opinions, printer, roller, show, sp mode, update, wait
    • Jomama46
      Field Supervisor

      Site Contributor
      2,500+ Posts
      • Apr 2008
      • 2900
      #2
      226 or 266?
      sigpic
      You never realize how cheap a professional is until after you let an amateur do it.
      A+; Network +; PDI+

        Comment

        • onegreatsteak
          Technician
          • Jan 2010
          • 14
          #3
          Sorry, bad typist 226,

            Comment

            • Jomama46
              Field Supervisor

              Site Contributor
              2,500+ Posts
              • Apr 2008
              • 2900
              #4
              Either a connector or the controller I would say.
              sigpic
              You never realize how cheap a professional is until after you let an amateur do it.
              A+; Network +; PDI+

                Comment

                Previous template Next
                Working...