i have a fuser code on this printer, i mainly do copiers, what is the clearing proceedure for this machine to clear this code, im assuming its like the copier, enter service mode, then re boot?if it comes back then its probly the thermister but ide like to clear it first.
-
-
Turn off/on the machine, then enter the service mode (SP) and set to 1 SP5-810. then turn off/on the machine again. -
ok gr8 and how do i enter the service mode on this printer?Comment
-
With the machine on and showing the SC, press and hold up and down, count to 5 really slowly, then release and press #. Reboot. If that doesn't clear the code, go to SP5-810, then reboot. If it happens again after that, new fuser time.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
-
ok thanks sounds good fuser's are charge item on this client! i smell money!$$$ LOLComment
-
ok how do i get into the sp mode?Comment
-
READ THE POSTS!Comment
-
Turn off/on the machine, then enter the service mode (SP) and set to 1 SP5-810. then turn off/on the machine again. ???With the machine on and showing the SC, press and hold up and down, count to 5 really slowly, then release and press #. Reboot. If that doesn't clear the code, go to SP5-810, then reboot. If it happens again after that, new fuser time.
where does it say how to enter the sp mode?
Comment
-
Dang, Dude. TonerMunkeh already told you. Press and hold up and down arrows. County slowly to 5. Release and press #. Now your in service mode.NEVER ASSUME ANYTHINGComment
-
As above to get into service mode.scroll to engine press#,then scroll to no.5(mode I think)press # then scroll to 5-810(sc reset)press# then # again,once it's said completed switch m/c off then back on againComment
-
oko ok got it
thanks lots dudesComment
Comment