The machine keeps jamming either at exit, before fusing unit or sometimes at registration area. Sensors are all ok by checking through SP mode. I replaced Paper Feed Unit, Transfer Belt; Fusing Unit and IO Board. Almost one month now but I'm run out of idea what to do. Anyone has experience same what I have? Please help. Thank you.
-
-
Re: MPC4000 Strange jamming..
What are the jam codes listed in the SMC report? -
Re: MPC4000 Strange jamming..
Does it have a finisher and bridge unit installed?Comment
-
Re: MPC4000 Strange jamming..
Thanks for the reply. The machine doesn't have finisher and bridge unit.Comment
-
Re: MPC4000 Strange jamming..
All I can think of off hand is have you tried adjusting the fuser entrance guide plate to its widest position?"See if you can rent a spring hook and a phillips screwdriver it will make your life that much easier..."Comment
-
Re: MPC4000 Strange jamming..
Some of those models did have faulty exit sensors at the fuser, usually give off a no paper A-B-C indication even when paper is in the machine. Otherwise the only other jam issues i get are from bad feed rollers, or bridge units and Sometimes ADF issues from paper dust.Comment
Comment