[Misc] MPC3003 Inport/Export setting to USB drive

[copier tech]

Hi all,

I'm swapping an mpc3003 for a faster mpc4503 & want to export all the settings, ip, smtp, address book etc to the new mpc4503, is it possible to do this via a usb stick drive, eg can I export the 3003 setting to USB drive then import them to the 4503?

I am aware I can do it via the WIM, but doing at the MFP via USB would be easier for me at this particular location.

Thanks.

[tankmurdock]

Re: MPC3003 Inport/Export setting to USB drive

I am pretty sure the only way to import or transfer information besides through the WIM is with an SD Card. You can import all the copiers settings onto a blank SD card then insert it into the new one and import. Add'y Book, NIC, SMTP, NVRam etc.

I don't think any service information can be obtained via a USB drive as of yet.

Hope that is helpful

[copier tech]

Re: MPC3003 Inport/Export setting to USB drive

I am pretty sure the only way to import or transfer information besides through the WIM is with an SD Card. You can import all the copiers settings onto a blank SD card then insert it into the new one and import. Add'y Book, NIC, SMTP, NVRam etc.

I don't think any service information can be obtained via a USB drive as of yet.

Hope that is helpful

Yes thats a great help, is the procedure under system tools?

[tankmurdock]

Re: MPC3003 Inport/Export setting to USB drive

No sir, it's all in the service mode of the copier...under the 5XXX-XXX section.

[ruben]

Re: MPC3003 Inport/Export setting to USB drive

Settings: SP5-749-001 to export (to SD?) and -101 to import, I believe, the SP modes are a bit vague.
Address Book: SP5-846-051 to export to SD and -052 to import.

[Moza]

Re: MPC3003 Inport/Export setting to USB drive

I think 03 models have the option to export device settings to usb in admin tools

[fbkhan3]

Re: MPC3003 Inport/Export setting to USB drive

Import.JPGImport 2.JPG yes it's possible to do but address book is exceptional, it's old traditional way through Sp for (address book backup). other settings can be import/export and managed with a SD card. in front slot in Operation Panel. make sure you have Admin Authentication ''ON'' to find the Import/export Option in system setting. Hope it helps

[copier tech]

Re: MPC3003 Inport/Export setting to USB drive

Thanks for the info here, I was able to back up & restore the address book to SD card in service mode no problem.

I also exported the machine settings to SD OK by using SP5-749-001 to export but when I tried to import using SP5-749-101 on the new machine it just said failed, any idea why?

It wasn't a big issue as I printed on the network settings etc on the old machine.