message "Cleaning Transfert belt" MX4111

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ben@km
    Technician
    • Sep 2014
    • 34
    #1

    [Misc] message "Cleaning Transfert belt" MX4111

    Hello everyone,
    I have an MX4111 with an MXLC11 that when used, will feed 2-3 sheets and message "cleaning transfer belt" show then resume for a few more and the same message keep popping. I know it as to do with the sheet being delayed to the PS Unit but what cause it ?? Feed rollers and clutches were replaced. Now I'm thinking the one way on the feed roller shaft + the torque limiter.
    Any other ideas please ?
    Thanks in advance.
    Tags: None
    • harleyrider
      Trusted Tech

      250+ Posts
      • Oct 2011
      • 348
      #2
      Re: message "Cleaning Transfert belt" MX4111

      check out TT-20307. For a different model but might be worth a shot.

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22999
          #3
          Re: message "Cleaning Transfert belt" MX4111

          Any time you get a jam in the registration area, you'll see the "cleaning ..." message. A typical cause is loss of transfer belt drive, specifically the gear on the "D" shaft that drives the belt unit. =^..^=
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • drowranger
              Trusted Tech

              100+ Posts
              • Jul 2015
              • 122
              #4
              Re: message "Cleaning Transfert belt" MX4111

              you can adjust the resist buckle of LCC to fix this on sim 51-2 > engine section > item w

              first try increasing by 10 and see it improves. this is trial and error so you have to try different values and set the best value

              Good luck!

                Comment

                • mansart
                  Senior Tech

                  Site Contributor
                  500+ Posts
                  • Apr 2009
                  • 852
                  #5
                  Re: message "Cleaning Transfert belt" MX4111

                  Does this machine have the LCC? If so replace the two clutches in the LCC unit.

                    Comment

                    • sharptech
                      Technician
                      • May 2011
                      • 40
                      #6
                      Re: message "Cleaning Transfert belt" MX4111

                      I agree with mansart. Every time I have had this same problem changing the 2 magnetic clutches in the LCC has resolved the issue.

                      T.G.G.

                        Comment

                        Previous template Next
                        Working...