When I print with Windows gives the following error
Cable tested and is safe.
Cable tested and is safe.
-
-
Re: error in print im3511
What model?
That attachment is too small to read. -
Re: error in print im3511
Oh, that's a Cannon.
This is the Sharp section.Comment
-
Re: error in print im3511
Actually SwisSeV, this Oce' is a rebadged Sharp AR-M350N series, but I can't make anything of the photo either. Maybe you can attach a smaller image? You might also check what driver version, what driver emulation, what driver manufacturer, etc, etc. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: error in print im3511
Haven't seen that one yet, thanks blackcat.Comment
-
-
Re: error in print im3511
The printer is printing out the literal commands that are being sent instead of translating them into an image. I would delete the driver entirely of Maharat's computer and download the latest one. Try a different driver PCL6, PCL5e, or PS(If enabled)
Also make sure the firmware is the latest.
If nothing has changed on the network or with the computer then it could be the controller PWB.sigpicComment
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment