[CQ] vertical line issue arm.236

[GREATMAN]

Thanks because i know u will respond.i have done the following.
1.cleaned optics and.mirrors.
2.Cleaned the lsu and serviced the drum.and.developer unit.
3.Changed drum,cleaning blade and charger is good.
4.Cleaned.the mylar and side door.
5.Heater unit is okay. What am i missing?

[bilyahn]

Re: vertical line issue arm.236

Did you actually change the cleaning blade? From your image I would say that it is the cleaning blade that is your problem. Have had this happen quite often on this series of machine.

Good luck.

Bil

[GREATMAN]

Thanks for your reply.yes sir.i changed cleaning blade

[vlad_]

Re: vertical line issue arm.236

What am i missing?

Make a printout of the memory of the SIM 64-1, 2 And see if there is a band or not.

[dwarf]

Re: vertical line issue arm.236

it looks like it might be a score line from a separation pawl in the fuser... run a blank sheet..

[OlliK1969]

Re: vertical line issue arm.236

Change the charger please

[GREATMAN]

Sorry for replying late i found out that there was a rust inside the scanner.

[lky1978]

Re: vertical line issue arm.236

Sorry for replying late i found out that there was a rust inside the scanner.