Sharp ar-m455n h4-01

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • J_Lee
    Trusted Tech

    100+ Posts
    • Oct 2008
    • 111
    #1

    Sharp ar-m455n h4-01

    Tried 2 BRAND NEW oem fusers and checked lamps on both. Reset with simulation works fine until machine gets turned off and gets cold again when you turn it back on it pops the code again. I reset fuser temps to default also. Any help?

    Thanks J.
    Tags: arm455n, h401, identical, lef, sharp, sharp ar, wrong
    • CopierTechofOmens
      Agitating Artificer

      250+ Posts
      • Jan 2009
      • 268
      #2
      Use DIAG (SIM5-2) to check the heater lamp
      Blinking operation.
      If the heater lamp blinks normally:
      Check the thermistor and its harness.
      Check the thermistor input circuit in the
      control PWB.
      If the heater lamp does not light:
      Check for heater lamp disconnection and
      thermostat disconnection.
      Check the interlock switch.
      Check the AC PWB and the lamp control
      circuit in the control PWB.
      Use DIAG (SIM14) to cancel the trouble.

      But you already knew that from reading the manual
      sigpic

        Comment

        • J_Lee
          Trusted Tech

          100+ Posts
          • Oct 2008
          • 111
          #3
          I dont post on this site unless I have read the manual. Ended up being wrong fuser sent to us by our parts distributor. Though identical they use different voltages.

            Comment

            • blackcat4866
              Master Of The Obvious

              Site Contributor
              10,000+ Posts
              • Jul 2007
              • 22999
              #4
              We need more members like you.
              Thanks for posting the results. =^..^=
              If you'd like a serious answer to your request:
              1) demonstrate that you've read the manual
              2) demonstrate that you made some attempt to fix it.
              3) if you're going to ask about jams include the jam code.
              4) if you're going to ask about an error code include the error code.
              5) You are the person onsite. Only you can make observations.

              blackcat: Master Of The Obvious =^..^=

                Comment

                Previous template Next
                Working...