network printing

[swagreis]

i have a small problem that in AR M450 i can not print network i am sure from the sequence of copier installation in PC and i am sure also from IP sequence because i made it many times and it works.
the printing order going out from PC and there is no action in machine
i changed the PC ,network card, and the same result no print


in the same place i changed the machine and give it the same IP that i put it in the last machine with thw same PC and it work correctly .
an yone can advise???

[xeroxsharp]

Did you try to ping the copier?
TCP IP -enable in network set up on user interface!
Is network card activated??????????
did copier print as network printer before?
when you configured printer driver,what are your port setings? protocol-LPR enable not RAW, next lp , next counting LPR enable , next SNMP enable

[swagreis]

i made LPR enable not raw as usual
but u said enable SNMP and LPR counting enable
i am always not to enable these check boxes and working ok in all machines
but do u mean by enable network card??
if there a simulation for that?
thanks for u

[xeroxsharp]

i made LPR enable not raw as usual
but u said enable SNMP and LPR counting enable
i am always not to enable these check boxes and working ok in all machines
but do u mean by enable network card??
if there a simulation for that?
thanks for u

Try to test your network card in another copier,if it works something must be wrong with your setings-(driver or copier)

[tmaged]

If you're installing it where you had a cougar in place, check the port. Cougars printed through port 10001, Tigers through 9100. Using the same IP address will not work if the port is incorrect.