MX2600N - The secondary belt moves to the right

[Marcello Zuccolo]

Good morning everyone.
I have a sharp MX2600N that has an unusual problem, and I wanted to know if anyone else has had it. The secondary belt moves to the right. I replaced it and it still moves, creating paper jams on the front and back.. Any ideas?

Thanks EVERYONE!

[ihatefinishers13]

Replaced the belt, or the whole unit? With that age, the whole unit should have been replaced. Normally the belt rides off when it's old, and bushings, springs, other small parts tend to wear out. Also, was it NEW, or used?

[ron67601]

I agree with ihatefinishers13 always replace with new. Everyone i've ever had do that it went away with a new replacement.

[Marcello Zuccolo]

Do you have the code for that part that maybe is still there??

Thanks.

[Doug.P]

Do you have the code for that part that maybe is still there??

Thanks.

CFRM-1380DS51 part number or supply item MX-310U2

[leo34staffs]

MX‐310B2

[Doug.P]

MX‐310B2

That is the belt only not the whole unit Whole Unit is MX-310U2

[Marcello Zuccolo]

Everyone is very efficient and kind. Thank you.