BP-70C45 can not select mono

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • boutn
    Senior Tech

    500+ Posts
    • Jun 2016
    • 540
    #1

    BP-70C45 can not select mono

    After installing a new BP-70C45 on several terminal servers, regular users can not select 'mono' (administrator can)

    They can only select Color or Automatic. Mono isnt even visible...

    Latest pcl6 driver is used, also tested with the PS driver, same problem.

    Installed on ip-port, no wsd.

    Does this ring a bell with anyone?
    Tags: None
    • ihatefinishers13
      Senior MFP Technician

      500+ Posts
      • Feb 2020
      • 668
      #2
      I've seen that before when GPO is pushing that, are they using Group Policy?

        Comment

        • ihatefinishers13
          Senior MFP Technician

          500+ Posts
          • Feb 2020
          • 668
          #3
          Or perhaps you setup a preset, instead, go toto Printer Properties > Advanced tab > Printing Defaults, and leave everything alone. That's where the defaults preferences are set whenever a driver is pulled down from the server.

            Comment

            • boutn
              Senior Tech

              500+ Posts
              • Jun 2016
              • 540
              #4
              rebooting the servers took care of this one...
                ๐Ÿ‘ 1

                Comment

                • ihatefinishers13
                  Senior MFP Technician

                  500+ Posts
                  • Feb 2020
                  • 668
                  #5
                  Originally posted by boutn
                  rebooting the servers took care of this one...
                  ...well... wasn't expecting that one! But at the same time, not surprised it worked haha.

                    Comment

                    Previous template Next
                    Working...