BP-C535WD developer units

[sharpie]

How the heck do you perform BPc535wd developer unit removal?

[ihatefinishers13]

How the heck do you perform BPc535wd developer unit removal?

Did you follow what's in the manual? Also, there's a new training section for this series as well, shows how to remove it, especially because the drum and dv units are locked together when you pull it out of the machine.

[sharpie]

Sharp tech support had a machine and they were unable to remove theirs either

[ihatefinishers13]

From the videos I watched the other day, the transfer belt had two rods on the right side that had to be rotated, pulled, and then rotated again to lift the rods so the belt doesn't touch the drums. We've only set up one of these and it's already in the field, haven't touched it yet. What part of the instructions aren't working out?

[boutn]

From the videos I watched the other day, the transfer belt had two rods on the right side that had to be rotated, pulled, and then rotated again to lift the rods so the belt doesn't touch the drums. We've only set up one of these and it's already in the field, haven't touched it yet. What part of the instructions aren't working out?

The two rods have to be pulled out before you can remote the drum/developer units