changed LSU and Main board from good M205 still get code shortly after power on
help needed
help needed
-
-
Did you replace the mirror motor only, or the laser assembly? In either case I have gotten a few new inoperative Sharp laser units.
Also try replacing the ribbon cable. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
M205 L6 sub10
customer LSU works in our test M205 copier
same with main board
why the ribbon cable?
thanks for the replyComment
-
It is very easy to damage the foil thin connections at the ends of the ribbon cable. All it takes is a razor thin crack in one of the conductors. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment